Which sequence correctly describes the stop signal procedure?

• A. Put your arms in an X; Point to your eyes and then to the rider; Point to the slide and make a spinning motion with your hand; Give thumbs up
• B. Wave to the rider; Point to the slide; Give thumbs up; Put arms in an X
• C. Put your arms in an X; Give thumbs up; Point to rider; Point to slide
• D. Stop and wait for supervisor

Answer: (A)

A standardized stop signal sequence is used to halt a ride quickly and communicate clearly with riders. First, forming an X with the arms is the universal, highly visible stop cue that tells everyone to stop moving. Next, you direct your gaze to your eyes and then to the rider to make sure the rider sees you and understands the signal. This helps ensure the message is received, not just sent. Then you point to the slide to indicate the area or element involved and perform a spinning motion with your hand to reinforce that motion should cease and to draw attention to the need for a pause or check. Finally, a thumbs-up shows that the area has been checked and it’s safe to resume or proceed once all conditions are verified. This sequence combines a clear stop cue, confirmation of rider attention, area-specific guidance, and formal clearance, which is why it’s the best answer for describing a stop signal procedure.